Update Stat Stock Box Firmware

To Update your Stat stock box's firmware you first will need to have three things downloaded:

• Stat Stock Provisioner: https://marietta-staging-bucket.s3.amazonaws.com/StatStockReaderProvisioning0.2.0.zip

• Firmware File: https://www.sensthys.com/wp-content/uploads/2023/05/SAEnt_Updates_23.05.30.51.zip
  • make sure to unzip this file and save it to a place in your computer you remember

• Sensthys Console to connect to Stat Stock Box: https://www.sensthys.com/wp-content/uploads/2024/04/ProSensConsole_v2.1.5.7.zip

Once you have these downloaded you are ready to begin.

1. Make sure your computer is connected to the same network as your Stat Stock box.
2. Open the Sensthys Console on your computer and wait for your Stat Stock box to appear. When it pops up select the check box to the left of it's name.

3. Navigate to updates

4. Select browse

5. Navigate to your "SAEnt_Update" by navigating to the unzipped folder and clicking in through the folders until you get to the update file.

6. Once the file is in place, click "update". This will reset your reader to default setting meaning you will need to re-provision the device.

7. Once the update has run open the Stat stock provisioner app to re-provision the Stat Stock box
8. Log in with your own credentials you would use to log into your Stat Stock site

9. On step 1, enter the IP and Serial number of the box then click "Connect". You can find this on your Stat Stock website if you go Settings gear -> Readers -> Click on the reader you are provisioning. You can see the details on this page.

10. On Step 2, click "Apply"

11. On step 3, click "Next" in the bottom right corner

12. On step 4, click "Apply"

13. On step 5, if you are changing the IP address you will save the new DNS. If you are not, click "Skip".

14. You have completed the process! Test your Stat Stock box in your Stat Stock website to make sure the update was successful and your Stat Stock box is connected.