How to Edit a Monitor

If you need to make adjustments to a monitor, enable audible alerts, or enable/modify notifications, follow these steps:

From your dashboard, click 'Monitors' at the top of the page.
locate the monitor you wish to edit.
Click on the three-dot icon ( ⋮ ) associated with the monitor and select 'Edit'. OR Click directly on the monitor to open its page, then click 'Edit' on the top right corner.

Edit Monitor Configuration:

Monitor Details:

Name: Assign or modify the monitor's name for easier identification.
Alarms: Toggle audible alarms on or off.
Timezone: Adjust the monitor's timezone for accurate data logging.
Firmware Updates: If unlocked, the monitor will receive regular over-the-air (OTA)
updates. If locked, select the specific firmware version for your monitor.

Notifications:

Running on power: notification for when a monitor starts running on external power
Running on battery: notification for when a monitor starts running on battery backup.
low battery: notification for when a battery's charge is getting low (<30%)
No battery: notification for when the battery is close to dead (<15%)
Poor Network Quality: notification for when network quality is poor (<20%)Low drive space: notification for if the monitor SD card gets low (<2000kbs)
No detected sensors: notification for if there are no sensors detected in your monitor.

Edit Multiple Monitors:

To apply the same settings to multiple monitors, perform a mass edit on parameters such as firmware settings and notifications.

Click 'Monitors' at the top of the Stat Temp website to go to the Monitor data grid page.
On the Monitor data grid page, select the monitors you want to assign the new settings to. A blue bar will appear with various options.
Click on 'Edit Selected' to open a side panel for configuring the desired settings.
Ensure all configurations are set correctly, then click 'Save' at the bottom of the panel to apply the changes.